DN NA Class

I'm going to place an order for some Sitka spruce, but I have no idea how much to order...

I obviously need two long pieces for the sides.  12' boat... So should I get two 14' lengths for the sides?  Will that be enough?  Do to the bends and curves, I'm just not sure.  I don't want to order all that and end up too short.

How much extra will I need beyond that?

You would think there would be an exact list somewhere of how much wood is needed, but I can't seem to track that down.

Any help is obviously appreciated.  I have a full workshop at my disposal and Sitka spruce available.  I think I'm going to order those full size plans for my first build.  But I'm in the dark on how much wood I'll really need.

Thanks in advance everyone!


Carter Brown
icesailing.net

      I have built several hulls but I use my own plans so I might not use exactly the wood you'd need but it should be close.  For the sides to be on the safe side get two 13 foot boards, most boats need about 12 1/2'. The boards should be a little wider then the max width of the side boards. For the internal structure I generally need a 1x8 by 8 ft. board. It's nice to have wood for the cockpit bulkhead that matches the sides, but that's dealers choice. I have used basswood, poplar or cedar for the internals.
     You will need about 1 1/3 sheets of 1/8"/3mm okoume or marine grade mahogany plywood. The bottom skin takes quite a beating and it's not uncommon to have to replace sections so I use 1/8" Luan ( I had source a source for high grade Luan ). Some of the boats I've built have been sailing for over 18 years and the Luan has never been a problem. I hope this helps.      Bob

Yes, big help.. Thank you!