|
Title: Anyone have a sketch or drawing for a Runner Light Box? Post by: Staggersnjaggs on November 05, 2009, 04:16:53 PM I'm looking for a sketch or drawing for a Runner Light Box.
It would save time if I could get my hands on a drawing... Thanks Title: Re: Anyone have a sketch or drawing for a Runner Light Box? Post by: Ken Smith on November 06, 2009, 09:28:26 PM Built it, never drew it.
I mounted a fluorescent desk lamp on two 1 by 3 boards for a base. Used a bit of counter top scrap for the table above the light which was mounted beneath and just past the end of the table. A gap of about 1-1/2 inch past the table is the light path, then a straight piece of steel for the reference surface, mounted above the light and past the table so a runner edge can touch the straight, flat steel surface when the runner body is on the table. Tune the gap properly, and a winged runner can lay with the wing in the gap. I used a 30" piece of finished 3/4 by 1 inch steel bar from a supply company, McMaster Carr. They sell stuff with a machined surface and mine was flat. It is an ugly tool, scrap wood and table top, sheet rock screws hold the bar down, but now has 12 years of use and is fine for its purpose. The steel was bought retail, the rest was scrap or yard sale stuff, total cost about $20. Ken _____ || ------ \|/ .........O... end view (elevation) |