DN NA Class  

DN America Forums

May 24, 2019, 10:02:19 AM *
Welcome, Guest. Please login or register.

Login with username, password and session length
 
   Home   Help Search Login Register  
Pages: [1]
  Print  
Author Topic: Asymmetric runner grind profile  (Read 431 times)
Maxim R161
Newbie

Posts: 4


« on: March 03, 2019, 07:33:03 PM »

Hello everyone.
Through my entire first DN racing season I was suffering with poor side runners grip.
Major cause of it is mediocre edge maintaining. I have a lot to learn in this department.
However, aside from that, I am long curious of why exactly asymmetric grind profiles (chisel profile in extreme) do not work (or everyone would probably use em).

My possible pros and cons suggestions are as follows:
+ we want side runners to hold in one direction each so why use symmetric profile on side runners at all?
+ chisel grind seems to be waaaay easier to execute and maintain
+ asymmetric grind could probably have broader angle than symmetrical without compromising grip and thus have less friction

- this is unconventional and scary and everyone is fine with symmetrical so just go practice sharpening))
- chisel runners could simply go apart from each other due to unbalanced ice pressure (my major concern)
- chisel shape could behave poorly as (if) negative camber develops with plank bend under load. probably not so much of a problem with less radical asymmetric shapes

Any thoughts are appreciated.
Logged
rlc
Class Member
*
Posts: 10



« Reply #1 on: March 14, 2019, 12:15:32 PM »

I can tell you that this has been tried, although not recently to the best of my knowledge. I have seen older plate runners that were ground asymmetrically.  I have no idea whether or not they worked or were fast, etc. etc.  Perhaps somebody with more experience would know more about what happened.

US3433
Logged
Pages: [1]
  Print  
 
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1 RC3 | SMF © 2001-2006, Lewis Media Valid XHTML 1.0! Valid CSS!