Jane has obvious sentiments involved in this issue. Fot the record, I voted no on this proposal, I don't think it will add significantly to the abilityto identify boats, and I like the look of my barbished hull.
However, it was voted on, and passed with a solid majority, well over the 2/3 required, so obviously my opinion was in the minority. It might also make an easier job for the scorers trying to keep track of boats at the mark roundings. If you don't believe how hard readiing the sail numbers can be, I suggest you stand out there and get a feel for the job the scorers have, better yet offer to help.
Jane is correct that NA sailors never voted on National letters, but I will be putting them on my boat. Heck, if I have to put the numbers on, what's two more letters. Firstly, I'm proud to sail for the North American team, and secondly I think it will be one more step towards helping the scorers.
To answer Bob's questions, first let me say the Technical Committee is discussing the issue, and will need to put out an Interpretation to make things more clear. But let me comment on the issue - some things that people (like Bob) have been asking are really very clear, others not so clear. Also, I took a look around and Bob is right about not finding the new Specifications anywhere, I will try to correct that today.
Breaking down the new letter/number Spec:
--- New hull side lettering ---
- 1) "National letter and Sail number shall be affixed to each side of the fuselage"
Lettering shall be put on both hullsides - obvious.
- 2) "below the mast stepping point"
This is less obvious. I think placing the lettering anywhere below the level of the top deck will be ok, keeping it close to the mast step (near the front of the cockpit) is a good idea, especially since thepointis to make it easy to read.
You've already read Jane's take on the National letters, and Commodore Harper's comments. Me - I'm putting National Letters on my boat. The letters are not specified by the IDNYRA, but I'm putting "US" on my boat.
- 3) "Color shall contrast with the fuselage":
Pretty obvious, the color of the lettering must contrast with the color of your hull. Again, the idea is to make it easy to read.
- 4) "each letter and number shall be a minimum of 5.5 inches (140 mm) high"
Lettering height, obvious again, they must be at least 5.5" (140 mm).
- 5) " and 0.7874 inches (20 mm) wide"
Less obvious until you think about it, the "stroke width" (the width of the lines making up the letters) must be at least 0.7874" (20 mm) wide.
Now for what isn't written...
- Font - The font is optional. Please stick with block capital letters, not too much slant, and avoid anything too fancy, like script fonts. The idea is to make it easy to read.
- Lettering width - The width of the letter will be determined by the height of the font you choose.
Paul Goodwin
Chairman IDNIYRA Technical Committee